LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 115 (Rear Drive Axle, Differential - Ford 8.8-Inch Ring Gear) >> In-Vehicle Servicing >> Rear Wheel Bearing & Axle Shaft Seal >> Installation

Rear Wheel Bearing & Axle Shaft Seal: Installation

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using rear axle lubricant, lubricate the new rear wheel bearing.
  2. Using the special tool, install the rear wheel bearing.
    3. Fig 1: Install Rear Wheel Bearing
    GF0013944Courtesy of FORD MOTOR CO.
  3. Using long-life grease, lubricate the lip of the new wheel bearing oil seal.
  4. Using the special tool, install the wheel bearing oil seal.
    5. Fig 2: Install Wheel Bearing Seal
    GF0013945Courtesy of FORD MOTOR CO.
  5. Install the axle shaft. For additional information, refer to Axle Shaft .
    6. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM article. Failure to follow these instructions may result in serious personal injury.
  6. Repower the system.
scientia non olet · About LEMON Manuals