Clutch Master Cylinder

Clutch Master Cylinder





Removal and Installation

WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. For additional Information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.

NOTICE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic surface, immediately wash the surface with water.

1. Disconnect the clutch master cylinder hose from the brake master cylinder.
- Plug the brake master cylinder.

- Plug the clutch master cylinder hose.

2. Remove the 2 clutch master cylinder nuts.
- To install, tighten to 23 Nm (17 lb-ft).

3. Disconnect the clutch master cylinder push rod.

4. Disconnect the clutch hydraulic fluid tube fitting.
- Plug the clutch hydraulic fluid tube.

5. Remove the clutch master cylinder.

6. To install, reverse the removal procedure.
- Bleed the air from the system.