LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Electronic Engine Controls - 2.3L) >> Removal And Installation >> Powertrain Control Module (PCM) >> Installation

Powertrain Control Module (PCM): Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the PCM and the 4 bolts.
    • Tighten to 8 Nm (71 lb-in).
  2. Connect the 2 PCM electrical connectors.
  3. Install the battery tray. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  4. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation (PMI) procedure. For additional information, refer to MODULE CONFIGURATION article.
  5. Reprogram the Passive Anti-Theft System (PATS). Carry out the Parameter Reset procedure. For additional information, refer to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) article.
scientia non olet · About LEMON Manuals