LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine - 2.3L) >> In-Vehicle Servicing >> Oil Pump Screen and Pickup Tube >> Removal And Installation

Removal And Installation

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove the oil pan. For additional information, refer to Engine Lubrication Components - Exploded View  and Oil Pan .
    3. NOTE: Discard the gasket and clean and inspect the gasket mating surfaces.
  3. Remove the 2 bolts and the oil pump screen and pickup tube.
    • To install, tighten to 10 Nm (89 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals