Removal And Installation
WARNING: This page is about a different variant/trim than selected.
All vehicles
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
- If equipped, remove the 7 screws and the underbody cover.
- Remove the 2 bolts and position the clutch slave cylinder aside.
- To install, tighten to 22 Nm (16 lb-ft).
- Disconnect the Engine Oil Pressure (EOP) switch electrical connector.
- Remove the EOP switch.
- To install, tighten to 15 Nm (133 lb-in).
- To install, reverse the removal procedure.
- Apply thread sealant to the EOP switch threads.
Vehicles equipped with manual transaxle
All vehicles