LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine - 2.3L) >> In-Vehicle Servicing >> Crankshaft Front Seal >> Installation

Crankshaft Front Seal: Installation

WARNING: This page is about a different variant/trim than selected.
    NOTE: Remove the through bolt from the special tool.
    NOTE: Lubricate the oil seal with clean engine oil.
  1. Using the Camshaft Front Oil Seal Installer, install the crankshaft front oil seal.
    2. Fig 1: Installing Crankshaft Front Oil Seal Using Special Tool
    G03897717Courtesy of FORD MOTOR CO.
  2. Install the crankshaft pulley. For additional information, refer to Crankshaft Pulley .
scientia non olet · About LEMON Manuals