Secondary Shaft To Gear Clearance
WARNING: This page is about a different variant/trim than selected.
SECONDARY SHAFT TO GEAR CLEARANCE
| Gear | Shaft Outer Diameter | Gear Inner Diameter | Clearance |
|---|---|---|---|
| 1st | 39.445-39.470 mm (1.553-1.554 in) |
39.500-39.525 mm (1.555-1.556 in) |
0.030-0.080 mm (0.002-0.003 in) |
| 2nd | 34.945-34.965 mm (1.376-1.377 in) |
35.000-35.025 mm (1.378-1.379 in) |
0.05-0.09 mm (0.002-0.003 in) |
| 3rd | 35.945-35.970 mm (1.415-1.416 in) |
36.000-36.025 mm (1.417-1.418 in) |
0.030-0.080 mm (0.002-0.003 in) |
| 4th | 30.945-30.970 mm (1.218-1.219 in) |
31.000-31.025 mm (1.220-1.221 in) |
0.030-0.080 mm (0.001-0.003 in) |
| 5th | 33.945-33.970 mm (1.3365-1.3373 in) |
34.000-34.025 mm (1.3386-1.3395 in) |
0.030-0.080 mm (0.0012-0.0031 in) |