Gearshift Cables: Removal

WARNING: This page is about a different variant/trim than selected.

Remove the heater core and evaporator core housing. For additional information, refer to CLIMATE CONTROL article.
Remove the battery tray. For additional information, refer to BATTERY, MOUNTING AND CABLES article.

NOTE: Carefully disconnect the spring clip, do not damage the spring clip.

Disconnect the gearshift cables from the shift mechanism.
- Pull the spring clip out of the groove. Lift upward to rotate the clip 90 degrees.

Fig 1: Pulling Spring Clip Out Of Groove (1 Of 2)

Courtesy of FORD MOTOR CO.

Fig 2: Pulling Spring Clip Out Of Groove (2 Of 2)

Courtesy of FORD MOTOR CO.

NOTE: Carefully pry the retainer on the shift cable. Do not damage the shift cable retainers.

Fig 3: Locating Gearshift Cables From Transaxle Bracket

Courtesy of FORD MOTOR CO.

Remove the clamp nut and the gearshift cable clamp.
Remove the restraints control module (RCM). For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM article.
Position the insulation blanket aside.
Remove the 2 gearshift cable nuts and detach the cables from the floor.
- To install, tighten to 8 Nm (71 lb-in).

NOTE: Carefully disconnect the cable from the shift lever assembly. Do not damage the shift cable retainers.

Fig 4: Locating Gearshift Cables

Courtesy of FORD MOTOR CO.