LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 926 (Body Panel System - Front End Body Panels) >> Removal And Installation >> Fender Splash Shield >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 3 fender splash shield bolts.
    • To install, tighten to 8 Nm (71 lb-in).
  2. Remove the 7 fender splash shield pin-type retainers.
  3. Remove the 6 fender splash shield screws.
  4. Remove the fender splash shield.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals