LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 910 (Accessory Drive System - 3.0L (4V)) >> Removal And Installation >> Accessory Drive Belt >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove the bolts and the RH splash shield.
    • To install, tighten to 7 Nm (62 lb-in).
  3. Using a suitable belt tensioner release tool, rotate the accessory drive belt tensioner counterclockwise and remove the accessory drive belt.
    4. NOTE: Refer to the illustration for correct drive belt routing.
  4. To install, reverse the removal procedure.
    5. Fig 1: Drive Belt Routing
    GF0024460Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals