LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 91 (Handles, Locks, Latches And Entry Systems -- F250-F550 Super Duty) >> Removal And Installation >> Interior Door Handle - Rear, Crew Cab >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Position the watershield aside.
  3. Release the interior rear door handle cover.
    • Release the clips.
      Fig 1: Releasing Interior Rear Door Handle Cover
      G03911831Courtesy of FORD MOTOR CO.
  4. Remove the inside door handle.
    1. Remove the nuts.
    2. Remove the inside door handle.
      Fig 2: Removing Inside Door Handle
      G03911832Courtesy of FORD MOTOR CO.
  5. NOTE: If a new component is to be installed, refer to the Ford Master Parts Catalog for specific part information.
  6. To install, reverse the removal procedure.