LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 91 (Handles, Locks, Latches And Entry Systems -- F250-F550 Super Duty) >> Removal And Installation >> Door Lock Actuator >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the door latch. For additional information, refer to FRONT DOOR LATCH  or DOOR LATCH - REAR, CREW CAB  in this article.
  2. Remove the door ajar switch. For additional information, refer to DOOR AJAR SWITCH  in this article.
    3. NOTE: The front door latch is shown, the rear door latch is similar.
  3. Remove the door lock actuator.
    1. Release the tab.
    2. Slide the door lock actuator off the latch.
    3. Remove the door lock actuator.
      Fig 1: Removing Door Lock Actuator
      G03911864Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.


  1. Remove the door latch. For additional information, refer to FRONT DOOR LATCH  or DOOR LATCH - REAR, CREW CAB  in this article.
  2. Remove the door ajar switch. For additional information, refer to DOOR AJAR SWITCH  in this article.
    3. NOTE: The front door latch is shown, the rear door latch is similar.
  3. Remove the door lock actuator.
    1. Release the tab.
    2. Slide the door lock actuator off the latch.
    3. Remove the door lock actuator.
      Fig 1: Removing Door Lock Actuator
      G03911864Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals