LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Charging System - General Information -- F250-F550 Super Duty) >> Diagnosis And Testing >> Charging System - Dual Generators >> Component Tests >> Generator On-Vehicle Test - No-Load Test

Generator On-Vehicle Test - No-Load Test

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Switch the tester to the voltmeter function.
  2. Connect the voltmeter positive lead to the generator B+ terminal and the negative lead to ground.
  3. Turn all electrical accessories off.
  4. With the engine running at 2,000 rpm, check the generator output voltage. The voltage should be between 13.0 and 15.5 volts. If not, refer back to the pinpoint test or GO to SYMPTOM CHART  for the diagnostic procedures.
scientia non olet · About LEMON Manuals