LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 834 (Horn System (F250-F550)) >> Removal And Installation >> Horn >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the battery tray. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  2. Remove the bolt.
    • To install, tighten to 9 Nm (80 lb-in).
  3. Remove the RH front fender splash shield. For additional information, refer to FRONT END BODY PANELS article.
  4. Disconnect the electrical connector and remove the horn.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals