LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 824 (Safety Belt System - F250-F550) >> Removal And Installation >> Safety Belt Buckle - Front, Bucket Seat >> Removal And Installation >> All seats

All seats

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Driver side shown, passenger side similar.
  1. Remove the affected seat. For additional information, refer to SEATING article.


  1. Remove the nut and the safety belt buckle.
    • To install, tighten to 40 Nm (30 lb-ft).
    Fig 1: Locating Safety Belt Buckle Nut
    GF0005415Courtesy of FORD MOTOR CO.
  2. To install, reverse the removal procedure.
  3. Check the active restraint system for correct operation. For additional information, refer to Safety Belt System  in this article.