LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 804 (Windows And Glass -- F250-F550 Super Duty) >> Removal And Installation >> Window Regulator - Front Door >> Installation

Window Regulator - Front Door: Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the regulator assembly in the full UP position, position the window regulator motor on the new regulator assembly and install the motor bolts.
    • Tighten to 13 Nm (10 lb-ft).
    Fig 1: Identifying Window Regulator Motor Bolts
    GF0005174Courtesy of FORD MOTOR CO.
  2. Position the counterbalance spring on the regulator assembly as shown.
    Fig 2: Identifying Counterbalance Spring
    GF0005175Courtesy of FORD MOTOR CO.
  3. Install the locking tab of the counterbalance spring into the regulator assembly.
    • Make sure the counterbalance spring is firmly seated into the regulator assembly.
    Fig 3: Identifying Locking Tab
    GF0005176Courtesy of FORD MOTOR CO.
  4. Install the regulator and motor assembly. For additional information, refer to Window Regulator and Motor - Front Door  in this article.
scientia non olet · About LEMON Manuals