LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 802 (Accessory Drive System - F250-F550 Super Duty) >> Removal And Installation >> Accessory Drive Belt - 6.0L Diesel >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the cooling fan stator - 6.0L diesel engine. For additional information, refer to ENGINE COOLING article.
  2. Rotate the drive belt tensioner clockwise and remove the accessory drive belt.
    3. Fig 1: Rotating Accessory Drive Belt Tensioner Clockwise - 6.0L Diesel
    G03887093Courtesy of FORD MOTOR CO.
    NOTE: Refer to Accessory Drive  for correct drive belt routing.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals