LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 791 (Engine Cooling System - F250-F550) >> Removal And Installation >> Cooling Fan - Blade, Clutch and Shroud, 5.4L, 6.8L >> Removal And Installation >> 5.4L engines

5.4L engines

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: The large clutch assembly nut has a right-hand thread and must be rotated counterclockwise to remove it.
  1. Using the special tool, remove the fan and fan clutch from the coolant pump pulley.
    • To install, tighten to 133 N.m (98 lb-ft).
    2. Fig 1: Removing Fan And Fan Clutch From Coolant Pump Pulley
    GF0005880Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals