Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
Remove the 3 pushpins and position the air deflector aside.

Fig 1: Locating Fasteners

Courtesy of FORD MOTOR CO.

Using the special tool, disconnect the fluid cooler tubes from the fluid cooler.

Fig 2: Locating Fluid Cooler Tubes And Special Tool

Courtesy of FORD MOTOR CO.

Remove the 2 bolts and remove the transmission fluid cooler.
- To install, tighten to 15 Nm (11 lb-ft).

Fig 3: Locating Auxiliary Transmission Fluid Cooler Bolts

Courtesy of FORD MOTOR CO.

To install, reverse the removal procedure.