LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 761 (Automatic Transmission External Controls - F150 & Mark LT) >> Removal And Installation >> Transmission Selector Lever - Floor Shift >> Removal

Transmission Selector Lever - Floor Shift: Removal

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the floor console left side kick panel.
    2. Fig 1: Removing Floor Console Left Side Kick Panel
    GF0003779Courtesy of FORD MOTOR CO.
  2. Lift the console storage lid cover and remove the console finish panel.
    3. Fig 2: Locating Console Finish Panel
    GF0003780Courtesy of FORD MOTOR CO.
  3. Disconnect the transmission selector lever cable from the arm of the transmission selector lever.
    4. Fig 3: Locating Transmission Selector Lever Cable
    GF0003781Courtesy of FORD MOTOR CO.
  4. Disconnect the transmission selector lever cable from the transmission selector lever cable bracket on the transmission selector lever.
    5. Fig 4: Locating Transmission Selector Lever Cable Bracket
    GF0003782Courtesy of FORD MOTOR CO.
  5. Remove the transmission selector lever bolts.
    6. Fig 5: Locating Transmission Selector Lever Bolts
    GF0003783Courtesy of FORD MOTOR CO.
  6. Disconnect the transmission selector lever electrical connector and remove the selector lever from the vehicle.
    7. Fig 6: Connecting Transmission Floor Shift Harness Electrical Connector
    GF0003784Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals