LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 761 (Automatic Transmission External Controls - F150 & Mark LT) >> Removal And Installation >> Transmission Selector Lever - Floor Shift >> Installation

Transmission Selector Lever - Floor Shift: Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the transmission selector lever assembly in the console and install the bolts.
    • Tighten to 12 Nm (9 lb-ft).
    2. Fig 1: Installing Transmission Floor Shifter Assembly Screws
    GF0003783Courtesy of FORD MOTOR CO.
  2. Connect the transmission selector lever harness electrical connector.
    3. Fig 2: Connecting Transmission Floor Shift Harness Electrical Connector
    GF0003784Courtesy of FORD MOTOR CO.
    NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the cable end is snapped onto the ball stud. Press the selector lever cable into the bracket and listen for the cable to click in place. Pull back on the selector lever cable to make sure that it is locked into the bracket. Also make sure that the selector lever cable end is correctly installed onto the ball stud. Pull back on the selector lever cable end to make sure that the cable end is correctly installed.
  3. Install the transmission selector lever cable in the transmission selector lever cable bracket.
    4. Fig 3: Locating Transmission Selector Lever Cable Bracket
    GF0003782Courtesy of FORD MOTOR CO.
    NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the cable end is snapped onto the ball stud. Press the selector lever cable into the bracket and listen for the cable to click in place. Pull back on the selector lever cable to make sure that it is locked into the bracket. Also make sure that the selector lever cable end is correctly installed onto the ball stud. Pull back on the selector lever cable end to make sure that the cable end is correctly installed.
  4. Connect the transmission selector lever cable to the transmission selector lever arm.
    5. Fig 4: Locating Transmission Selector Lever Cable
    GF0003781Courtesy of FORD MOTOR CO.
  5. Install the console finish panel.
  6. Install the left console kick panel.
scientia non olet · About LEMON Manuals