LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 741 (Safety Belt System - F-150 & Mark LT) >> Removal And Installation >> Safety Belt Retractor - Front, Without Seat Integrated Restraints (SIR) >> All retractors

All retractors

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front and rear door scuff plate.
  2. Open the D-ring cover.
  3. Remove the D-ring nut.
    • To install, tighten to 40 Nm (30 lb-ft).
  4. Remove the B-pillar trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.


  1. Remove the safety belt anchor bolt.
    • To install, tighten to 47 Nm (35 lb-ft).
  2. Remove the safety belt retractor bolt and the safety belt retractor.
    • To install, tighten to 47 Nm (35 lb-ft).
  3. To install, reverse the removal procedure.


  1. Check the active restraint system for correct operation. For additional information, refer to Safety Belt System  in this article.
scientia non olet · About LEMON Manuals