Rear seat cushion or backrest

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

Pull some of the safety belt webbing out of the rear center safety belt retractor, slide the rear seat backrest under the webbing and position it into the vehicle.

Fig 1: Sliding Rear Seat Backrest Under Webbing

Courtesy of FORD MOTOR CO.

NOTE: Make sure the seat backrest lower retaining clips are completely seated before installing the seat backrest.

NOTE: Make sure the safety belt webbing is not twisted prior to installation.

NOTE: Make sure that the safety belt buckles are accessible after seat installation.

To install, align the locators near the right center of the backrest and press the backrest downward until the retaining clips are engaged.
Install the safety belt cover.
- Place the cover over the safety belt tower.
- Install the 2 nuts.
- Install the fasteners cover.

Make sure the safety belts and buckles are accessible to the occupants after installation.