LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 715 (Windows And Glass - F-150 & Mark LT) >> Removal And Installation >> Window Regulator Motor - Rear >> Removal

Window Regulator Motor - Rear: Removal

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear trim panel pin-type retainers.
    Fig 1: Identifying Rear Trim Panel Pin-Type Retainers
    GF0002005Courtesy of FORD MOTOR CO.
  2. Remove the rear trim panel.
  3. Remove the rear corner trim. For SuperCab vehicles, remove the B-pillar trim panel. For SuperCrew vehicles, remove the C-pillar trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
  4. Disconnect the rear window glass motor electrical connector.
  5. Remove the 3 rear window glass regulator and motor assembly screws.
    Fig 2: Identifying Rear Window Glass Regulator And Motor Assembly Screws
    GF0002015Courtesy of FORD MOTOR CO.
  6. Carefully remove the 3 bolts attaching the steel bracket to the plastic cable housing.
    Fig 3: Identifying Steel Bracket Bolts
    GF0002016Courtesy of FORD MOTOR CO.
  7. Hold the plastic cable housing and motor together, place a screwdriver between the drum (located in the cable housing) and the motor housing and pry the motor away from the drum, making sure the drum stays inside the plastic cable housing.
    Fig 4: Holding Plastic Cable Housing And Motor
    GF0002017Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals