Window Regulator Motor - Rear: Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

Align the motor gear splines onto the drum and press the motor into place, making sure there is correct alignment of the attachment bolt holes.
- Install the 3 bolts attaching the steel bracket to the plastic cable housing.
Fig 1: Identifying Steel Bracket Bolts
Courtesy of FORD MOTOR CO.
Install the rear window glass regulator and motor assembly screws.
- Tighten to 11 Nm (8 lb-ft).
Fig 2: Identifying Rear Window Glass Regulator And Motor Assembly Screws
Courtesy of FORD MOTOR CO.
Connect the rear window glass motor electrical connector.
Install the rear corner trim. For SuperCab vehicles, install the B-pillar trim panel. For SuperCrew vehicles, install the C-pillar trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
Install the rear trim panel.
Install the rear trim panel pin-type retainers.

Fig 3: Identifying Rear Trim Panel Pin-Type Retainers
Courtesy of FORD MOTOR CO.