LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 715 (Windows And Glass - F-150 & Mark LT) >> Removal And Installation >> Window Glass - Front Door >> Removal >> All vehicles

All vehicles

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
  2. Remove the front door interior moulding.
  3. Position aside the front door watershield.
  4. Remove the front door below belt bracket bolt and bracket.
  5. Temporarily install the window control switch or the window crank and lower the window to access the glass-to-regulator assembly bolts.
  6. Loosen the front door window glass-to-regulator assembly bolts.
  7. Tape the window in position, then lower the front door window regulator to the full downward position.
    8. NOTE: The top run may be positioned aside to gain additional clearance if needed.
  8. Tip the front of the glass down and pull the front door window glass out through the top outboard side of the door.
scientia non olet · About LEMON Manuals