LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 714 (Accessory Drive System - F-150 & Mark LT) >> Removal And Installation >> Accessory Drive Belt - 4.2L >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Rotate the tensioner counterclockwise and remove the drive belt.
    2. Fig 1: Rotating The Tensioner Counterclockwise
    GF0002422Courtesy of FORD MOTOR CO.
    NOTE: For additional information, refer to Accessory Drive  in the Description and Operation portion of this section for correct drive belt routing.
  2. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals