LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 708 (Electronic Engine Control System - F-150 & Mark LT) >> Removal And Installation >> Clutch Pedal Position (CPP) Switch >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the clutch pedal position (CPP) switch electrical connector.
  2. Detach the pushrod from the clutch lever pin.
  3. Remove the CPP switch.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals