LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 708 (Electronic Engine Control System - F-150 & Mark LT) >> Removal And Installation >> Camshaft Position (CMP) Sensor - 5.4L (3V) >> Removal And Installation >> Both sides

Both sides

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the camshaft position (CMP) sensor electrical connector.
  2. Remove the bolt and the CMP sensor.
    • To install, tighten to 10 Nm (89 lb-in).
  3. To install, reverse the removal procedure.
    • Lubricate the CMP sensor O-ring seal with clean engine oil prior to installation.
scientia non olet · About LEMON Manuals