Removal and Installation
WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
RH side shown, LH side similar.
- Remove the rear door inside handle bezel screw cover.
- Remove the upper rear door inside handle bezel screw.
- Remove the rear door inside handle bezel.
- Lift upward on the rear of the rear door inside handle bezel.
- Disconnect the electrical connector.
- Remove the rear door handle screw cover.
- Remove the rear door handle screw.
- Remove the rear door trim panel upper screw.
- Remove the rear door trim panel.
- Pull the rear door trim panel outward to release the rear door trim panel pin-type retainers.
- To install, reverse the removal procedure.
NOTE:
The back of the rear door trim panel shown with the location of the rear door trim panel pin-type retainers indicated.