LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 667 (Interior Trim And Ornamentation) >> Removal And Installation >> Door Trim Panel - Front >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: RH side shown, LH side similar.
  1. Remove the front door handle bezel screw cover.
  2. Remove the front door inside handle bezel screw.
  3. Remove the front door inside handle bezel.
    • Lift upward on the rear of the front door inside handle bezel.
    • Disconnect the electrical connector.
  4. Remove the front door handle screw cover.
  5. Remove the front door handle screw.
  6. Remove the front door trim panel upper screw.
  7. Remove the front door trim panel lower screw.
    8. NOTE: The back of the front door trim panel shown with the location of the front door trim panel pin-type retainers indicated.
  8. Remove the front door trim panel.
    • Pull the front door trim panel outward to release the front door trim panel pin-type retainers.
    • Disconnect the electrical connector.
      Fig 1: Locating Front Door Trim Panel Pin-Type Retainers
      G04683076Courtesy of FORD MOTOR CO.
  9. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals