LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 666 (Horn) >> Removal And Installation >> Horn >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the 4 RH front fender splash shield screws.
    • Pull the RH front fender splash shield downward to access the horn.
  3. Disconnect the electrical connector.
  4. Remove the bolt and the horn.
    • To install, tighten to 10 Nm (89 lb-in).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals