Pinpoint Test G: The Illuminated Entry Is Inoperative When Using The Remote Keyless Entry (RKE) Transmitter

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

G1 CHECK FOR CORRECT RKE OPERATION
- Using the RKE transmitter, lock and unlock the doors.
- Do the doors lock and unlock?
Yes : GO to G2.

No : REFER to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS to continue diagnosis of the RKE system.
G2 CHECK FOR CORRECT SJB OPERATION
- Disconnect all the SJB connectors.
- Check for:
  - Corrosion
  - Pushed-out pins
- Connect all the SJB connectors and make sure they seat correctly.
- Operate the system and verify the concern is still present.
- Is the concern still present?
Yes : INSTALL a new SJB. REFER to MULTIFUNCTION ELECTRONIC CONTROL MODULES . TEST the system for normal operation.

No : The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. TEST the system for normal operation.