Turbine Shaft Speed (TSS) Sensor And Intermediate Shaft Speed Sensor: Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Install the intermediate shaft and turbine shaft combination speed sensor.
1. Lubricate the O-ring and install the intermediate shaft and turbine shaft combination speed sensor.
2. Install the bolt.
  
  Fig 1: Installing Intermediate Shaft And Turbine Shaft Combination Speed Sensor Bolt
  Courtesy of FORD MOTOR CO.
Connect the intermediate shaft and turbine shaft combination speed sensor electrical connector.

Fig 2: Identifying Intermediate Shaft And Turbine Shaft Combination Speed Sensor Electrical Connector
Courtesy of FORD MOTOR CO.
Raise transmission into position.
Position the crossmember to the transmission insulator and retainer, and loosely install the nut.

Fig 3: Locating Crossmember To Transmission Mount
Courtesy of FORD MOTOR CO.
Install the LH crossmember bolts.

Fig 4: Installing LH Crossmember Bolts
Courtesy of FORD MOTOR CO.
Install the RH crossmember bolts.

Fig 5: Installing RH Crossmember Bolts
Courtesy of FORD MOTOR CO.
Install the bracket and loosely install the bolts.
1. Install the bracket.
2. Loosely install the bolts.
  
  Fig 6: Installing Bracket And Bolts
  Courtesy of FORD MOTOR CO.
Tighten the RH crossmember bolts.

Fig 7: Tightening RH Crossmember Bolts
Courtesy of FORD MOTOR CO.
Tighten the transmission insulator and retainer nuts.

Fig 8: Rear Transmission Mount Insulator Nuts - With Torque Specification
Courtesy of FORD MOTOR CO.
Install the wire harness and install the two retaining clips to the rear of the crossmember.

Fig 9: Locating Wire Harness At Rear Of Crossmember
Courtesy of FORD MOTOR CO.