LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 612 (Climate Control) >> Removal And Installation >> Temperature Blend Door Actuator - RH, Dual-Zone EATC >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the passenger air bag module. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM .
  2. Disconnect the RH temperature blend door actuator electrical connector.
  3. Remove the 2 RH temperature blend door actuator bracket screws.
  4. Detach the wire harness from the RH temperature blend door actuator bracket.
  5. Remove the RH temperature blend door actuator.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals