LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 612 (Climate Control) >> Removal And Installation >> Blower Motor Resistor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the blower motor resistor electrical connector.
  2. Remove the blower motor resistor screw.
  3. Remove the blower motor resistor.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals