LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 561 (Exterior Trim And Ornamentation) >> Removal And Installation >> Door Molding - Rear >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the rear door.
  2. Remove the 4 rear door molding retaining bolts.
    Fig 1: Identifying Rear Door Molding Retaining Bolts
    G04658505Courtesy of FORD MOTOR CO.
  3. Release the rear door molding retaining clips.
    • Start at the rear lower portion of the rear door molding, moving forward along the rear door.
  4. Remove the rear door molding.
  5. To install, reverse the removal procedure.
    • It is necessary to install new rear door molding retainers anytime the rear door molding is removed.
scientia non olet · About LEMON Manuals