LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 561 (Exterior Trim And Ornamentation) >> Removal And Installation >> Door Molding - Front >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the front door retaining clips.
    • Start at the rear lower portion of the front door molding, moving forward along the front door.
    Fig 1: Identifying Door Molding - Front
    G04658504Courtesy of FORD MOTOR CO.
  2. Remove the front door molding.
  3. To install, reverse the removal procedure.
    • It is necessary to install new front fender molding retaining clips anytime the front door molding is removed.
scientia non olet · About LEMON Manuals