LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 551 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Front Door Lock Actuator >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the door latch. For additional information, refer to FRONT DOOR LATCH  or REAR DOOR LATCH .
  2. Release the tab on the door lock actuator and slide it off the door latch.
    Fig 1: Locating Tab On Door Lock Actuator
    G04659057Courtesy of FORD MOTOR CO.
  3. To install, reverse the removal procedure.