LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 550 (Anti-Lock Brake System) >> Diagnosis And Testing >> Anti-Lock Control >> Pinpoint Tests >> Pinpoint Test I: Spongy Brake Pedal with No Warning Indicator >> Pinpoint Test I: Spongy Brake Pedal With No Warning Indicator

Pinpoint Test I: Spongy Brake Pedal With No Warning Indicator

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. I1 CHECK THE VEHICLE COMPONENT MOUNTING 
    • Inspect the brake pedal and brake booster/brake master cylinder for correct attachment.
    • Bleed the brake system. Refer to BRAKE SYSTEM BLEEDING .
    • Is the brake pedal still spongy? 

    Yes:  GO to  I2.

    No:  The brake system is operating correctly. The concern may have been caused by air in the hydraulic system.

  2. I2 BLEED THE BRAKE SYSTEM 
    • Bleed the brake system using the diagnostic tool. Refer to BRAKE SYSTEM BLEEDING .
    • Is the brake pedal spongy? 

    Yes:  REFER to BRAKE SYSTEM-GENERAL INFORMATION .

    No:  The brake system is operating correctly. The concern may have been caused by air in the hydraulic control unit (HCU).

scientia non olet · About LEMON Manuals