LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 538 (Accessory Drive) >> Removal And Installation >> Accessory Drive Belt >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the 7 pin-type retainers and the RH splash shield.

    3. Freestyle only 

  3. Remove the 3 A/C compressor pulley shield retainers and the shield.

    4. All vehicles 

  4. Using a suitable belt tensioner release tool, rotate the accessory drive belt tensioner counterclockwise and remove the accessory drive belt.
    5. NOTE: Refer to Fig 1 for correct drive belt routing.
    Fig 1: Identifying Accessory Drive Belt Components
    G04656135Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals