LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 530 (HVAC Control System) >> Removal And Installation >> Temperature Blend Door Actuator - RH >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lower the glove compartment.
  2. Remove the 3 RH temperature blend door actuator screws.
  3. Disconnect the RH temperature blend door actuator electrical connector.
  4. Remove the RH temperature blend door actuator.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals