Removal and Installation
WARNING: This page is about a different car, the 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the battery tray. For additional information, refer to BATTERY, MOUNTING AND CABLES .
- Remove the horn bolt.
- To install, tighten to 9 Nm (80 lb-in).
- Remove the RH front fender splash shield. For additional information, refer to FRONT END BODY PANELS .
- Disconnect the electrical connector and remove the horn.
- To install, reverse the removal procedure.