LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 495 (HVAC Control System-General Information And Diagnostics - F250-F550 Super Duty) >> General Procedures >> Refrigerant Oil Adding >> Refrigerant Oil Adding >> Notes

Refrigerant Oil Adding: Notes

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: During normal A/C operation, oil is circulated through the system with the refrigerant, and a small amount is retained in each component. If certain components of the system are removed, some of the refrigerant oil will go with the component. To maintain the original total oil charge, it is necessary to compensate for the oil lost by adding oil to the system with the new part.
  1. Refer to the chart below for refrigerant oil adding amounts and methods of installation.
PAG OIL AMOUNT REFERENCE

Component PAG Oil Amount Method of Adding
A/C Compressor See heading below Add directly to A/C compressor before installation.
Suction Accumulator or Receiver/Drier See heading below Add directly to suction accumulator inlet port or inject to low-side service port during system charging.
Evaporator Core 45 ml (1.5 fl oz) added to the amount collected during refrigerant recovery Add directly to evaporator core inlet tube or inject to low-side service port during system charging.
Condenser Core 60 ml (2 fl oz) added to the amount collected during refrigerant recovery Add directly to condenser core inlet or inject to low-side service port during system charging.
Evaporator Core Orifice or Thermostatic Expansion Valve The amount collected during refrigerant recovery Inject to low-side service port during system charging.
A/C Pressure Relief Valve 60 ml (2 fl oz) added to the amount collected during refrigerant recovery Inject to low-side service port during system charging.
Refrigerant Hose/Line 60 ml (2 fl oz) added to the amount collected during refrigerant recovery(1) Inject to low-side service port during system charging.
O-ring Leak Repair 60 ml (2 fl oz) added to the amount collected during refrigerant recovery(2) Inject to low-side service port during system charging.
Service Port Leak Repair 60 ml (2 fl oz) added to the amount collected during refrigerant recovery Inject to low-side service port during system charging.
(1) If an excessive amount of refrigerant oil is lost due to a hose rupture/separation or other damage, the total system refrigerant oil capacity must be added.
(2) The amount specified may be used for one or multiple O-ring leak repairs. Do not multiply the refrigerant oil amount by the number of O-ring leaks being repaired.
scientia non olet · About LEMON Manuals