LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 489 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Push Button Rod - Linkage, Horizontal, Rear Door, Crew Cab >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Release the guide clip from the door lock linkage.
    Fig 1: Locating Guide Clip
    G04646468Courtesy of FORD MOTOR CO.
  3. Disconnect the door lock actuator from the rear door latch.
  4. Remove the push button rod actuator from the bellcrank.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals