Removal and Installation
WARNING: This page is about a different car, the 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The door glass must be in the raised position to remove the exterior door handle.
- Remove the rear door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
- Position the watershield aside.
- Remove the body plug.
- Remove the 2 exterior door handle nuts.
- To install, tighten to 9 Nm (80 lb-in).
- Release the exterior door handle actuating rod clip and remove the exterior rear door handle.
- To install, reverse the removal procedure.