LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 489 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Door Lock Actuator >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the door ajar switch. For additional information, refer to DOOR AJAR SWITCH .
  2. NOTE: The front door latch is shown, the rear door latch is similar.
  3. Remove the door lock actuator.
    1. Release the tab.
    2. Slide the door lock actuator off the latch.
    3. Remove the door lock actuator.
      Fig 1: Identifying Door Lock Actuator
      G04646483Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.