LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 480 (Exterior Lighting System) >> Removal And Installation >> Light Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the light sensor and bezel as an assembly.
    • Disconnect the electrical connector.
    2. NOTE: Take care not to break the retaining tabs.
    Fig 1: Locating Locking Tabs And Light Sensor
    G04645646Courtesy of FORD MOTOR CO.
  2. Disengage the locking tabs and remove the light sensor.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals