Removal and Installation
WARNING: This page is about a different car, the 2006 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the window regulator switch housing.
- If equipped with power windows, disconnect the electrical connector.
- If equipped, remove the window regulator handle.
- Remove the panel reflector.
- Remove the screws.
- Lift and remove the rear door trim panel.
- To install, reverse the removal procedure.
CAUTION:
Do not pull directly outward on rear door trim panel as damage will occur.
NOTE:
Remove the rear door trim panel by pulling it straight upward.
CAUTION:
Insert the lower panel tabs first or they can break when installing the rear door trim panel.