Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Regular and Crew Cab vehicles

Remove the rear trim panels. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .

SuperCab vehicles

Remove the child safety seat tether anchors. For additional information, refer to SAFETY BELT SYSTEM .
Remove the rear corner trim panels. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .

All vehicles

Disconnect the power sliding window cable retainer clips.

Fig 1: Locating Power Sliding Window Cable Retainer Clips

NOTE: Left side shown, right side similar.

Fig 2: Locating Left Cable Swag From Power Sliding Window

Remove the left cable swag from the power sliding window.
Remove the left transition block from the sliding window trough.

Fig 3: Locating Rear Sliding Window Trough
Remove the left transition block from the cable end.

Fig 4: Locating Left Transition Block From Cable End
Pull the left cable end out of the sliding window trough.

Fig 5: Pulling Left Cable End Out Of Sliding Window Trough
Repeat steps 5 through 8 for the right side.
Remove the power sliding window motor and bracket.
1. Disconnect the electrical connector.
2. Remove the bolts.
  - To install, tighten to 11 Nm (8 lb-ft).
    
    Fig 6: Identifying Electrical Connector Bolts